NeuroTrac Continence Is a Digital Dual Channel STIM unit suitable for;
- pelvic floor muscle strengthening
- urinary and faecal incontinence
- bladder frequency and urgency,
- lack of sensitivity of pelvic floor
- pelvic floor workout – combining several phases and parameters
- pain relief
- muscle strength and endurance.
The NeuroTrac Continence has 9 built in programmes and 3 customisable, work/rest programmes which are simple to set up.
NeuroTrac Continence EMS (electrical muscle stimulation) units are widely used by physiotherapists in their practices and you can now bring the same technology to the privacy of your own home, in a simple, user-friendly compact and reliable stimulation device.
The NeuroTrac Continence records the average current used plus the time in use along with the ability to lock the unit.
What is included?
- Continence electrical stimulation unit
- 9V Battery
- 2 lead wires ( connects electrodes to unit)
- User manual
- Soft storage case
Women can use electrical stimulation with either anal, vaginal or external electrodes. Men can use electrical stimulation with anal or external electrodes
WHAT IS INCLUDED?
- Continence electrical stimulation unit
- 9V Battery
- 2 lead wires ( connects electrodes to unit)
- User manual
- Soft storage case
SPECIFICATIONS
STIMULATION
- Dual channel: individually isolated circuits.
- Amplitude: 0 – 90 mA into 500 Ohm load; indication only. Actual mA will tend to be less than indicated due to electrode impedance: at 1000 Ohms load (Electrodes in poor condition) the maximum will be limited to 70 mA, at 1500 Ohms load the maximum will be limited to 65 mA.
- Type: Constant Current, maximum output voltage 180 Volts +10 / -30 Volts
- Waveform: Asymmetrical, rectangular bi-phasic with zero DC current.
- Selectable pulse width: 50 μS – 450 μS [2% accuracy].
- Pulse Rate selection: in the continuous mode 2 Hz – 100 Hz [2% accuracy].
- Time duration of the treatment selectable: 1 minute to 90 minutes.
- Low Battery Indicator: If the battery goes below 6.9 volts +/- 0.2 volts the battery symbol will flash on/off once every second.
- Open Electrode Detect: If an open circuit is detected at the output of channel A or B the output current will be reset at zero.
- Ramp up time 0.3 – 9.9 seconds.
- If the battery voltage is below 6.6 (+/- 0.2) volts the unit will not turn on.
Physical dimensions: 119.2 x 69 x 28.7 mm
Weight: 0.07KG without battery, 0.1KG with battery.
Environmental Conditions for use:
+10 to +30 degrees Centigrade. 0-90% Humidity.
Environmental conditions for storage & transport:
10 to +50 degrees Centigrade. 0-90% Humidity.